Maiden Flight › Setup guides › RadioMaster & EdgeTX
Bind your receiver
Binding pairs the receiver with this model. Use the section for your receiver's protocol. About 10-20 min. For: RadioMaster / EdgeTX.
You need
- Receiver installed with its power source (ESC BEC or receiver pack)
- PROPELLER REMOVED
ExpressLRS receivers
- Check firmware: the radio's ELRS module and the receiver must run the same major version (e.g. both 3.x). SYS > Tools > ExpressLRS shows the module version.
- Best method, a binding phrase: flash module and receiver with the same binding phrase (ExpressLRS Configurator). They connect automatically on power-up, with no bind mode needed.
- Without a phrase: power the receiver on-off-on-off-on (3 power-ups) until its LED double-blinks (bind mode). Then SYS > Tools > ExpressLRS > [Bind].
- A solid LED means connected. A slow blink means it is powered but sees no transmitter.
Bind once per receiver. With a binding phrase you can move a receiver between models without re-binding, but use Model Match (Safety) so it only answers the right model.
FrSky receivers (multi-protocol / CC2500 module)
- Internal RF: MULTI, protocol FrSky X2 for ACCST 2.x receiver firmware or FrSky X for 1.x. Use FrSky D8 for D8 receivers. ACCESS receivers cannot bind to a multi-protocol module.
- Hold the receiver's bind button while powering it on.
- On the radio select [Bnd] next to the receiver number. When the receiver LED shows bound (usually solid green with red flashing), stop binding and power-cycle the receiver.
Spektrum and FlySky receivers (full 4-in-1 module only)
- CC2500-only radios (Pocket, Zorro, Boxer, TX12 CC2500 versions) cannot bind Spektrum or FlySky receivers.
- Spektrum: Internal RF MULTI, protocol DSM, sub-protocol DSMX (or Auto). Put the receiver in bind mode (bind plug or button per its manual), then [Bnd].
- FlySky: protocol FlySky AFHDS2A, choosing the sub-protocol that matches the receiver's output (PWM or PPM with IBUS or SBUS). Then bind as per the receiver manual.
Check: you're done when
- The receiver LED shows connected.
- Moving a stick moves its servo.
- Telemetry (signal / link quality) appears on the radio.
Open this in Maiden Flight Free to start. Works on phone and computer.