Maiden Flight › Setup guides › RadioMaster & EdgeTX
Directions, centres and throws
This is where most crash-on-takeoff causes are removed. Take your time. About 20 min. For: RadioMaster / EdgeTX.
You need
- Throw gauge or ruler
- Your airplane's manual (recommended throws)
- Propeller removed
Centre mechanically first
- With the Channel Monitor at 0 on every channel, servo arms should be at 90 degrees to the pushrod and surfaces in line with the wing or stab.
- Adjust clevises or pushrod length to centre surfaces. Only fix the last little bit with Subtrim (Outputs). Large subtrim makes throw uneven left vs right.
Directions
- Stand behind the airplane. Aileron right: right aileron up, left down. Elevator stick back: elevator up. Rudder right: trailing edge right.
- Wrong way? Outputs > that channel > Direction: INV. Never fix direction in Inputs, because that reverses the stick for every channel that uses it.
Throws
- Measure at the widest part of the surface, per the manual's low and high rates.
- Set the throw with the rate (Inputs weight, see guide 8). Outputs Min/Max scale the servo's travel and are its absolute limit, so use them to stop the linkage binding. Nothing can drive the servo past them.
- At full stick, listen to each servo. Buzzing means it's stalled against a stop, so back the limit off until it's quiet.
Check: you're done when
- All surfaces centred with little or no subtrim.
- Every direction checked from behind the airplane.
- Throws match the manual, with no buzzing servos.
Open this in Maiden Flight Free to start. Works on phone and computer.