Maiden flight and first trims
The setup is only proven once it has flown. Make the first flight boring. About At the field. For: All radios.
You need
- Charged flight and radio batteries
- Pre-flight checklist (Safety)
On the ground EdgeTX
- CG at the manual's position (balance with the flight battery installed).
- Run the full pre-flight checklist: right model selected, directions, failsafe, throttle cut.
- Link check: walk-out test watching link quality (ELRS) or a range check (FrSky/multi).
- Low rates selected, timer set conservatively (e.g. 4-5 minutes for the first flight).
On the ground Spektrum
- CG at the manual's position (balance with the flight battery installed).
- Run the full pre-flight checklist: right model selected (ModelMatch), directions, failsafe, throttle cut on H.
- Range test with a helper holding the airplane. NX/DX: Function List > Range Test, then hold the trainer button so the screen shows reduced power. Stand about 30 paces (28 m) away and check you have full control. Telemetry alarms are off while it runs.
- iX: Model Setup > Range Test and follow the steps on screen. Try it with the airplane pointing a few different ways.
- Low rates selected, timer set conservatively (e.g. 4-5 minutes for the first flight).
In the air
- Take off into wind, climb to a comfortable height before trimming.
- Trim for hands-off level flight at cruise throttle: aileron first, then elevator.
- Do a few gentle turns and a power-off glide at height to feel the stall before landing.
After landing
- If any trim is more than a few clicks off centre, adjust the linkage to match and re-centre the trim. That keeps full trim range for next time.
- Note what you changed (throws, CG, trims) in the model notes.
Check: you're done when
- The airplane flies hands-off level at cruise.
- Trims are near centre after adjusting linkages.
Open this in Maiden Flight Free to start. Works on phone and computer.