Maiden Flight › Setup guides › RadioMaster & EdgeTX
First power-up: radio settings
Set the radio-wide options once. They apply to every model you create. About 10 min. For: RadioMaster / EdgeTX.
You need
- Radio
- A flat table
Radio Setup (SYS > Radio Setup)
- Date and time: set them so your telemetry logs have correct timestamps.
- Battery range and low-battery warning: match your radio's cells (for 2S Li-ion or LiPo, a warning around 7.0-7.2 V is typical; check your manual).
- Sounds: set voice language and volume. Voice alerts become important once telemetry is set up.
- Stick mode: confirm Mode 2 (or the mode you fly). This is radio-wide.
- Default channel order: set AETR (Aileron, Elevator, Throttle, Rudder). New models get their mixes in this order. All Maiden Flight guides assume AETR.
- Inactivity alarm: leave it on (e.g. 10 minutes), because it saves flat radio batteries.
Calibrate the sticks (SYS > Hardware > Calibration)
- Start calibration, leave all sticks and pots centred, and confirm.
- Move both sticks around their full range several times, and move every pot and slider end to end. Confirm to save.
- Check the result: with sticks centred, the inputs should read close to 0. At the ends they should reach -100 and +100.
Firmware check
- SYS > Version shows your EdgeTX version. Note it, because the SD card contents should match it.
- Don't update firmware right before a flying day. Update at home with a backup (see 'Updating EdgeTX safely' in the EdgeTX deep dive).
Check: you're done when
- Channel order is AETR.
- Sticks read about 0 centred and ±100 at full travel.
Open this in Maiden Flight Free to start. Works on phone and computer.