Maiden Flight › Setup guides › RadioMaster & EdgeTX
Throttle cut, failsafe and pre-start checks
Three settings that stop a spinning propeller hurting you. Full detail lives in the free Safety section. About 15 min. For: RadioMaster / EdgeTX.
You need
- Propeller REMOVED
- Flight battery
Throttle cut
- Special Functions: add 'Override CH3', value -100, on your cut switch, and tick enable.
- Only if you reversed CH3 in Outputs: use +100 instead. Override ignores Outputs reverse, so on a reversed channel -100 would be full throttle.
- Test: with throttle up a little (prop off), flip the switch. The motor must stop.
- For a proper arming sequence (motor only arms at idle), follow 'Safe arming sequence' in Safety.
Pre-start checks
- Model Setup > Pre-start checks: throttle warning on, and switch warnings set to your safe positions (cut switch in CUT).
- Now the radio warns you at power-up (and when you select the model) until the throttle is down and the switches are in their safe positions. Don't skip past the warning: fix the switch.
Failsafe
- Set failsafe so throttle goes to idle/off when the link is lost. ELRS PWM receivers: set it in the receiver's web UI. The default is centre on every output except output 3 (throttle low), so check any channel that must not go to centre. Multi-protocol: Custom with CH3 at -100.
- Test: arm, raise throttle slightly, switch the RADIO off. The motor must stop.
Check: you're done when
- Throttle cut stops the motor.
- Radio warns at power-up if throttle or cut switch isn't safe.
- Turning the radio off stops the motor.
Open this in Maiden Flight Free to start. Works on phone and computer.