Maiden Flight Open the app

Maiden Flight › Setup guides › Spektrum

Bind the receiver and use ModelMatch

Binding pairs the receiver with one model memory. On Spektrum it also stores the failsafe, so where the sticks and switches are during the bind matters. About 10 min. For: Spektrum.

You need

Before you bind

  1. Select the right model memory first.
  2. Throttle stick fully down, throttle trim down too. Put every other stick and switch where you want it if the link is lost (gear down, flaps up).
  3. The receiver won't go into bind mode if a radio it already knows is switched on before it. Switch the radio off first.

Bind (NX and DX)

  1. Put the receiver in bind mode: insert the bind plug in the BIND port, or hold the receiver's bind button, and power it up. The LED flashes.
  2. Radio side: hold the bind button while you switch the radio on, or go to System Setup > Bind (also in the Function List) without switching off.
  3. When the receiver LED goes solid, release the button, and remove the bind plug.

Bind (iX)

  1. Receiver in bind mode as above.
  2. Model Setup > Bind, or touch and hold BIND on the dashboard. Leave Telemetry Auto Config on: it sets up the telemetry screens after the bind.
  3. When the radio reports success, power the receiver off and on again.

ModelMatch and when to bind again

  1. ModelMatch is automatic. A receiver only answers the model memory it was bound with. Pick another model and the airplane ignores the radio.
  2. Copying a model does not copy the bind. A copied, reset, imported or retyped model must be bound again.
  3. Bind again after any change in Servo Setup (reverse, travel, sub-trim). The failsafe positions are stored at bind time and would be out of date.
  4. E-flite BNF airplanes with SAFE Select: SAFE is switched on or off by which bind sequence you use. Follow the airplane's manual for that sequence.

Newer E-flite BNF receivers can send a Smart Transmitter File (STF) with the full radio setup: create a blank model, bind, then LOAD and CONFIRM. It overwrites that model. NX radios on firmware 4.0.11 or newer and the iX14 and iX20 support it; the iX12 and DX radios don't.

Check: you're done when

Open this in Maiden Flight Free to start. Works on phone and computer.