Maiden Flight › Setup guides › Spektrum
Failsafe on Spektrum receivers
Spektrum failsafe is set in the receiver, mostly at bind time. Know which type yours uses, then prove it on the bench. About 20 min. For: Spektrum.
You need
- PROPELLER REMOVED
- Airplane held or strapped down
- Your receiver's manual
The three failsafe types
- SmartSafe: throttle only. No throttle signal while the radio is off, the ESC can't arm until throttle is low, and on signal loss the throttle goes to where it was at bind (low, if you bound with the stick down).
- Hold Last Command: every other channel stays where it was when the signal was lost.
- Preset: every channel goes to the position you stored. Useful for gear, spoilers and gliders.
- Most receivers bind with SmartSafe plus Hold Last by default. What your receiver supports depends on the model, so read its manual.
- If throttle has been moved off channel 1, SmartSafe can't find it: use Preset failsafe.
Preset failsafe on classic receivers
- Uses the bind plug. Insert it and power the receiver.
- Pull the bind plug out while the LEDs are still flashing.
- Put the sticks and switches where you want them on failsafe (throttle down, gear down).
- Power the radio on in bind mode, as in the bind guide. The positions you are holding are stored.
AR631+ and similar: Forward Programming
- These receivers bind with SmartSafe plus Hold Last. Preset is only reachable through Forward Programming.
- NX/DX: Function List > Forward Programming (it appears once a receiver that supports it is bound). iX: turn it on first in Model Setup > Menu Setup, then Model Adjust > Forward Programming.
- Forward Programming > Other Settings > Failsafe. Set each channel to Preset or Hold Last. Hold the sticks where you want them, choose Capture Failsafe Positions, then Apply. Channels you don't set stay on Hold Last.
- SAFE Failsafe (the airplane rolls level into a gentle descending turn) needs First Time SAFE Setup first (AS3X and SAFE guide). E-flite BNF airplanes with SAFE ship that way: throttle low, pitch and roll held in a descending turn.
Test it, every model
- Propeller off, airplane held. Arm, raise the throttle a little, put gear and flaps somewhere other than their failsafe position.
- Turn the radio's RF off. NX/DX: switch the radio off. iX: double-press power, choose RF off and hold OK.
- The motor must stop. Every other channel must go where you chose.
- Before you turn the RF back on, put the throttle down and the cut on.
- Repeat after any Servo Setup change, a bind, a receiver swap or a Forward Programming change.
Check: you're done when
- Throttle goes to off when the RF is turned off.
- Gear and flaps go to the positions you chose, or hold, as you intended.
- You bound with the throttle down after the last servo change.
Open this in Maiden Flight Free to start. Works on phone and computer.