Maiden Flight › Setup guides › Spektrum
Dual rates and expo
Rates scale the throw, expo softens the middle of the stick. On Spektrum they live in one menu, set per channel, on any switch you choose. About 15 min. For: Spektrum.
You need
- Recommended low and high throws from the airplane's manual
Set the rates on switch F
- NX/DX: Function List > D/R and Expo (Rates and Expo on newer NX firmware). iX: Model Adjust > Dual Rates and Expo.
- Rates work on aileron, elevator and rudder. Pick the channel, then set the switch to F.
- For each switch position set the rate and the expo. 100% is full travel and rates can only reduce it.
- Do the same for elevator and rudder, all on F, so one flick changes all three.
- E-flite's starting point for the Timber: high rate 100% with 10% expo, low rate 70% with 5%. Use your own airplane's numbers if the manual gives them.
Expo on Spektrum
- Positive expo makes the stick softer around centre. Negative makes it sharper. That is the same sign as EdgeTX.
- If the manual gives nothing, start low (10-25%) and add more after a flight. Measure the throws on each rate and write them down.
AS3X airplanes
- Don't take rates below 50% on an AS3X airplane. The gyro needs some stick authority to work properly.
- E-flite BNF setups sometimes use separate switches per axis (the Timber uses F, C and G). Following the airplane's own sheet is fine. Maiden Flight puts all three on F.
Check: you're done when
- Throws on both rates match the manual.
- F changes aileron, elevator and rudder together.
- No rate below 50% on an AS3X airplane.
Open this in Maiden Flight Free to start. Works on phone and computer.