Maiden Flight Open the app

Maiden Flight › Setup guides › Spektrum

Servo directions, travel and sub-trim

This is where most take-off crashes are prevented. Centre the linkages, get every surface moving the right way, then set the throws. About 20 min. For: Spektrum.

You need

Centre mechanically first

  1. Open the monitor screen and check each channel sits at 0 with sticks and trims centred.
  2. Servo arms should be at 90 degrees to the pushrod and surfaces in line with the wing or tail. Fix it at the clevis first.
  3. Only tidy up the last bit with Sub-Trim (in Servo Setup). Large sub-trim values make the throw uneven from side to side.

Directions

  1. Stand behind the airplane. Right aileron stick: right aileron up, left down. Elevator stick back: elevator up. Right rudder: trailing edge right.
  2. NX/DX: Function List > Servo Setup, roll to Travel, then left to Reverse, and select the channel. iX: Model Adjust > Servo Setup > Reverse.
  3. Reversing the throttle channel brings up a warning to bind again. Do it: if the failsafe still holds the old direction, a lost link can mean full throttle.
  4. Mixed surfaces (V-tail, elevons, two ailerons) have their own guides. Check them one surface at a time.

Travel and throws

  1. Travel in Servo Setup sets how far the servo goes. With the stick centred, both directions change together. Hold the stick to one side to change only that side.
  2. Measure the throw at the widest part of the surface. Use Travel to stop any servo binding at full stick, then set the flying throws with dual rates (next guides).
  3. At full stick listen to each servo. A buzz means it is stalled against something: reduce the travel on that side.
  4. Bind again when you're finished here, so the failsafe matches the new settings.

Check: you're done when

Open this in Maiden Flight Free to start. Works on phone and computer.