Maiden Flight › Setup guides › Spektrum
Throttle cut and safe arming
A Spektrum airplane has no separate arm switch. Throttle cut is your safety switch, and SmartSafe keeps the ESC from arming with the stick up. About 15 min. For: Spektrum.
You need
- PROPELLER REMOVED
- Flight battery
Set throttle cut on switch H
- NX/DX: Function List > Throttle Cut. iX: Model Adjust > Throttle Cut.
- Choose switch H. On iX you can pick it from the list or flick the switch. Mark the position that cuts the motor.
- Set the cut position to -100. That is what E-flite publishes for its airplanes on DX, NX and iX radios. If the throttle doesn't reach off on the monitor, try a lower value.
- Throttle cut works in every flight mode.
- Check it on the monitor: throttle stick halfway, flip H to cut. The throttle channel must drop to the off value.
If you ever reverse the throttle channel
- Spektrum's manuals don't say whether the cut value is applied before or after Servo Setup Reverse. Don't assume.
- After reversing throttle, bind again (the radio asks you to), then re-check the cut on the monitor and with the motor connected and the propeller off.
Power-up warnings
- The radio warns at power-up if the throttle is above about 10%. Leave that warning on.
- NX/DX: System Setup > Warnings can also warn about a switch position. Add a warning for H in its run position, so the radio complains if you power up without the cut on. iX: Model Setup > Model Start Warnings does the same and won't turn the RF on until the warning is cleared.
Arming an E-flite BNF airplane
- Throttle stick and throttle trim fully down. Throttle cut on.
- Switch the radio on and wait about 5 seconds.
- Connect the flight battery. Keep the airplane still and upright while the receiver starts up. The ESC beeps the cell count and then a double tone.
- From now on, once you switch the cut off, the motor follows the throttle stick. Treat the airplane as live.
- SmartSafe stops the ESC arming until the throttle is low, and sends no throttle while the radio is off. It is not a replacement for the cut switch.
Check: you're done when
- H cuts the throttle on the monitor in every flight mode.
- The radio warns at power-up if throttle is up.
- You arm in the order: radio on, wait, battery in, airplane still.
Open this in Maiden Flight Free to start. Works on phone and computer.