Maiden Flight › Setup guides › RadioMaster & EdgeTX
Sticks to servos: channels and wiring
Make sure each stick drives the right servo before worrying about directions. About 10 min. For: RadioMaster / EdgeTX.
You need
- Bound receiver
- Servos and ESC plugged in
- Propeller removed
Plug in to match the channel order
- Receiver output 1 = aileron, 2 = elevator, 3 = throttle (ESC), 4 = rudder (AETR).
- One aileron servo, or two joined with a Y-lead, goes on 1. Two ailerons on separate channels are covered in the Intermediate guides.
- The ESC's lead powers the receiver (BEC) unless you use a separate receiver battery. Check your ESC's BEC current can handle your servos.
Prove it with the Channel Monitor
- Open the Channel Monitor (in the Tools/Monitors menus). Move one stick at a time: only that stick's channel should move.
- Then watch the servos: the aileron stick moves only the aileron servo, and so on.
- Receivers with a serial output (SBUS/CRSF) to a flight controller: set the same AETR order in the flight controller software's receiver settings.
Check: you're done when
- Every stick moves exactly one channel and the right servo.
Open this in Maiden Flight Free to start. Works on phone and computer.